Why dsl filter

The only thing left for you to do is to disconnect the telephone line from the jack. Lastly, you can connect the telephone line into the DSL filter. One thing to keep in mind is that a DSL connection is different than a dial-up connection. This is because it does not occupy your phone like even though it shares the telephone line. By sharing the line and, a DSL device offers a much faster connection than the older dial-up method. It is way more efficient.

The DSL connection sends digital signals where your telephone sends voice signals. It makes use of the unused wires in the line for transmitting the digital signal.

This is the main reason why you can use both your telephone and internet connection on one line. If you do not use a splitter, you will get better quality in the connection by installing the DSL filter as the wires are so close to each other.

A DSL filter, also known as a micro-filter, is an analog low-pass filter between analog devices and a regular line for your home phone. So the question is if you really need a DSL filter. It comes in very handy due to various reasons as mentioned below:. This is because the same line can disrupt your DSL internet connection. Thus, it eliminates signals or echoes from an analog device from compromising performance and causing connection issues with DSL service.

You will need DSL filters installed on every device that connects to a DSL phone line especially if you are using a home phone service without a splitter setup. As mentioned before, equipment such as phones, fax machines, and regular modems tend to disrupt the telephone wiring when they are being used. This leads to disruption with the DSL signal over phone lines which eventually results in a poor connection and it can even interrupt DSL service. This persists as long as you are sending faxes, using the modem, or talking on the phone, etc.

Now, this is where a DSL filter plays its part. What does it do? It basically filters out this blockade so that you are able to freely use your phone without worrying about it interfering with the DSL signal. You can even get multipacks that have more than one filter in case you need to hook up more than one line in your house. The remarkable thing about DSL filters is that there is no need for calibration or setting up, once you install the filter in your phone jack.

These mechanisms are always on, which means you can automatically connect to the internet. You stay connected as long as you keep your modem hooked up to your phone line. They require zero maintenance and rarely quit working. Despite always working, a DSL filter will not affect your power bill or internet usage. It does not need batteries or a power supply. So you can plug this device into as many phone ports as you have without worrying about negative effects.

Plug it in and watch your internet and phone performance increase. Every device that connects to your phone line — except your modem — needs a DSL filter. You should have received 2 filters from Blackfoot along with your modem — one that is single port and one that is dual port.

Filters are plugged in between your jack and your device. To install one, plug the filter into a wall jack, and then plug a phone cord or other device into the other end. A DSL filter is not required if the split method is used.

In this case a technician visits the premises and installs a splitter in the main telephone cable. Two lines emerge from the splitter; one line feeds into standard phone jacks, while the other line is used exclusively for a DSL modem. A DSL filter is not required in this case because the splitter has separated the voice and data signals.

The second method, which has gained popularity because it does not require a technician, can be user-installed. In this case, the end-user can setup a DSL modem along with several micro-filters.